Table of Contents
Advertisement
4
Installing the Rinse Nozzles
Parts needed for this procedure:
2
Rinse nozzle
2
Bulkhead fitting
1
Gasket
2
Shoulder bolt
2
Bushing
2
Rinse vane
2
Plastic flange nut
2
90° fitting
Drilling the Spray Tank
1.
Open the tank lid and remove the strainer basket
(Figure
16).
Figure 16
2.
Locate the 2 drill marks in the main tank
17).
Note:
The drill marks are dimples molded into
the tank.
1. Drill marks
3.
Move to the drill mark behind the tank lid.
Note:
the areas where you are drilling to catch falling
debris.
Important:
clog and damage the spray system during
operation.
4.
Use a hole saw to make a hole—4.5 cm (1-3/4
inches) at the drill mark
g206491
(Figure
1. Drill mark (behind the lid)
5.
Remove any rough edges cut in the tank.
6.
Clean any debris that entered the main tank.
9
Figure 17
Place a container inside the tank below
Debris left inside a tank could
(Figure
Figure 18
2. Hole-saw bit—4.5 cm
(1-3/4 inch)
g206492
18).
g206493
Advertisement
Table of Contents
