Table of Contents
Advertisement
3.
Assemble the hoses—1.9 x 180 cm (3/4 x 71
inches) and a hose clamp onto the T-fitting as
shown in
Figure
4.
Tighten the 3 hose clamps that secure the 3
hoses to the T-fitting by hand.
Assembling the Fittings to the
Rinse-Tank Pump
Owner provided material: PTFE thread sealant
1.
Apply PTFE sealant to the threads of the 2
Straight-barb fitting.
2.
Install the 2 straight-barb fitting into the 2 ports
of the rinse-tank pump
Note:
Move the pump cover as needed to
provide access to the ports of the rinse-tank
pump.
Figure 28
1. Straight-barb fitting
2. Port (rinse-tank pump)
27.
(Figure
28).
3. Left side of the machine
4. Right side of the machine
Installing the Hoses and Filter
1.
Assemble the hose—53.3 cm (21 inches) at
the bottom of the rinse tank onto the inboard
straight-barb fitting of the rinse-tank pump with
a hose clamp, and tighten the clamp by hand
(Figure
27).
1. Hose clamp
2. Straight-barb fitting
(inboard—rinse-tank
pump)
2.
Assemble the hose—20.3 cm (8 inches) that
you cut in
outboard straight-barb fitting of the rinse-tank
pump with a hose clamp, and tighten the clamp
by hand
(Figure
g220001
14
Figure 29
3. Rinse tank
4. Hose—53.3 cm (21
inches)
Cutting the Hose (page 5)
30).
g219999
onto the
Advertisement
Table of Contents
