Table of Contents
Advertisement
Installing the Rocker Switch into
the Dash
1.
Remove the plug for the rinse tank switch from
the dash panel
(Figure 37
Note:
It is the second plug to the right of the
ignition key.
Figure 37
2015 and Before Machines
1. Plug
2. Connector for rinse tank
(main wire harness)
or
Figure
38).
g034584
3. 3-position switch (with
indicator light)
2016 and After Machines
1. Plug
2. Connector for rinse tank
(main wire harness)
2.
Working from underneath the dash panel,
remove the cable tie that secures the 8-socket
connector labeled R
harness.
3.
Route the 8-socket connector toward the open
hole in the dash
4.
Connect the 3-position switch into the 8-socket
connector through the dash panel
Figure
38).
5.
Insert the 3-position switch into the opening in
the dash panel until the latch of the switch snap
securely into the dash
18
Figure 38
3. 3-position switch (without
indicator light)
T
from the main
INSE
ANK
(Figure 37
or
Figure
38).
(Figure 37
(Figure 37
and
Figure
g034585
or
38).
Advertisement
Table of Contents
