Toro 02622 Operator's Manual

Toro 02622 Operator's Manual

Transport wheel kit, machine

Advertisement

Transport Wheel Kit
HoverPro
Model No. 02622

Safety

Before using this kit, refer to the machine Operator's
Manual safety section.
Do not lift the machine onto the transport wheel kit or
move the machine using the transport wheel kit while
the engine is running.

Setup

1. For models
02602/02603/02604/02606/02609/02610/02611,
with serial number range 314000000–314999999
only:
Drill a 6.4 mm (1/4 inch) diameter hole in the lower
handlebar of the machine (Part No. 111-7260-03), 360
mm (14.17 inch) from the bottom of the handlebar
(Figure
1).
Note: If there is already a hole at this location on the
handlebar, no drilling is required.
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
450/500/550 Machine
Register at www.Toro.com.
Vibration
Measured vibration level for the left hand = 7.7 m/s
02602); 3.1 m/s
2
(model 02604); 5.8 m/s
Measured vibration level for the right hand = 4.8 m/s
02602); 4.4 m/s
2
(model 02604); 4.0 m/s
Uncertainty Value (K) = 3.5 m/s
(model 02604); 3.0 m/s
2
(model 02606).
Original Instructions (EN)
All Rights Reserved *3404-808* A
Printed in the UK
Form No. 3404-808 Rev A
Operator's Manual
2
(model 02606).
2
(model 02606).
2
(model 02602); 2.0 m/s
Figure 1
2
(model
2
(model
2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 02622 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Toro 02622

  • Page 1 Form No. 3404-808 Rev A Transport Wheel Kit HoverPro ® 450/500/550 Machine Model No. 02622 Operator's Manual Safety Vibration Measured vibration level for the left hand = 7.7 m/s (model • Before using this kit, refer to the machine Operator’s 02602);...
  • Page 2 Operation 2. Attach the hook to one side of the lower handle bar using 1 hex bolt, 1 spacer, and 1 nyloc nut. Repeat for the other side (Figure Note: When mowing, ensure that the transport wheel kit is secured to the lower handle bar with both hooks. Note: Refer to Figure 2 for the correct orientation of...
  • Page 3 g018538 Figure 2 1. Hex bolt (2) 5. Nut (2) 9. Axle spacer (25 mm) (2) 13. Hex HD bolt (2) 2. Hook (2) 6. Washer (2) 10. Wheel (2) 14. Axle (1) 3. Spacer (2) 7. Undercarriage (1) 11. Axle spacer (300 mm) (1) 4.

This manual is also suitable for:

Hoverpro 450Hoverpro 500Hoverpro 550

Table of Contents