Table of Contents
Advertisement
Operation
Operating the Rinse Kit
Using the Rinse Kit will result in a rinsate (a diluted
solution of residual chemicals). In many cases, it
is appropriate to apply the rinsate onto a treated
area(s). However, before doing so, check with the
chemical manufacturer to ensure that the application
of a diluted solution to the treated area(s) does not
adversely affect the performance of the product.
Important:
The Rinse Kit is not intended to
dislodge clumped masses of wetable powder
or water-soluble chemicals that occur when
chemicals are not properly introduced into the
main tank.
Controls
The Rinse Kit is controlled by a 3-position switch
(Figure 40
or
Figure
41).
•
The rinse-tank pump is on with timed rinse when
you press the 3-position switch up position and it
locks—the delay timer runs the pump.
Note:
For 2015 and before machines, the switch
illuminates.
•
The rinse-tank pump is off when you press the
3-position switch to the middle position.
•
The rinse-tank pump is on momentarily: when you
press and hold the 3-position switch in the down
position to run the pump—the delay timer does
run the pump.
Note:
For 2015 and before machines, the switch
illuminates.
2015 Models and Before
1.
(up) position—timed
ON
rinse (the switch
illuminates)
2.
(middle) position
OFF
2016 Models and After
1.
(up) position—timed
ON
rinse
2.
(middle) position
OFF
Description of Operation
Operating the 3-Position Switch for a Timed
Rinse
Pressing up the 3-position switch starts a timed
rinse. The pump runs for 110 seconds and it pumps
approximately 1/3 of the rinse tank contents into the
main tank. During this time the switch stays in the
up position.
20
Figure 40
3.
(down)
ON
position—momentary
rinse (the switch
illuminates)
Figure 41
3.
(down)
ON
position—momentary
rinse
g034586
g034587
Advertisement
Table of Contents
