Table of Contents
Advertisement
Installing the Rinse-Pump Cover
Insert the 2 tabs of the rinse-pump cover into the 2
slots in the saddle plate of the tank frame
Figure 33
1. Tab (rinse-pump cover)
7
Installing the Delay Timer
and Dash Switch
Parts needed for this procedure:
1
Delay timer
2
Locknut (#10–24)
1
Fuse (40 A)
1
Relay
1
Power relay
2
Flange-head bolt (#10-24 x 1/2 inch)
3-position switch (with indicator light—2015 and
1
before turf sprayers)
3-position switch (without indicator light—2016 and
1
after turf sprayers)
Installing the Delay Timer, Relays,
and Fuse
1.
Raise the operator seat to access the electronic
components under the seat.
2.
For 2015 and before machines, perform the
following:
Important:
You do not need the delay timer
for 2016 and after machines.
(Figure
33).
g219998
2. Slots (saddle plate)
A.
Install the delay timer to the location shown
in
Figure 34
from the electrical panel.
B.
Connect the timer to the 2-socket connector
labeled delay timer of the machine wire
harness
(Figure 34
2014 and Before Machines
1. Electrical panel
2. Locknut (#10–24)
3. Delay timer
4. Delay timer connector
(machine wire harness)
5. Main wire harness
16
or
Figure 35
with the locknut
or
Figure
35).
Figure 34
6. Fuse block
7. Fuse (40 A)
8. Relay (5-pin)
9. Power relay (4-pin)
g015113
Advertisement
Table of Contents
