Pepperl+Fuchs IDENTControl IQH3-FP-V1 Manual page 23

IQH3-FP-V1
Operation
<FunctionNo> = 30
<Data 1> Infoflags
<Data 2> UID (LSB)
etc.
<Data 9> UID (MSB)
[<Data 10> DSFID]
[<Data 11> AFI]
[<Data 12> VICC memory size, number of blocks -1]
[<Data 13> VICC memory size, block size in bytes - 1]
[<Data 14> IC Reference]
Example
SG10 makes precisely one attempt to read the AFI or DSFID.
Meaning of the bytes in response .30.31.0F.BC.59.54.E8.7E.01.08.E0.00.39.F9.07.84
.30 = Status 0
.31 = 1
.0F = DSFID, AFI, VICC Memory Size, and IC Reference are supported
.BC.59.54.E8.7E.01.08.E0 = UID
.00 = DSFID
.39 = AFI
.F9 = 249
.07 = 7
.84 = IC Reference
Enhanced Get Configuration EG
The read/write head makes continuous attempts to read the AFI or DSFID.
Command:
Response:
<FunctionNo> = 30
<Data 1> Infoflags
<Data 2> UID (LSB)
etc.
<Data 9> UID (MSB)
[<Data 10> DSFID]
[<Data 11> AFI]
1. This data is only sent if the corresponding info flag is set in <Data 1> by the chip manufacturer. (See ISO15693-
3:2019 Chapter 10.4.12). If no data is sent, any subsequent data will move forward accordingly.
2. This data is only sent if the corresponding info flag is set in <Data 1> by the chip manufacturer. (See ISO15693-
3:2019 Chapter 10.4.12). If no data is sent, any subsequent data will move forward accordingly.
= '0'
hex
1
1<Default ¬¹ Font>
1<Default ¬¹ Font>
, command has been executed without error
ASCII
, IDENTControl channel 1
ASCII
, number of blocks -1
dec
, block size in bytes - 1
dec
EG <ChanNo> <FunctionNo> <CHCK> <ETX>
<Status> <ChanNo> <Data 1> <Data 2> ...<Data n> <CHCK> <ETX>
= '0'
hex
2
2<Default ¬¹ Font>
1<Default ¬¹ Font>
1<Default ¬¹ Font>
25