Parameters - Pepperl+Fuchs IDENTControl IQH3-FP-V1 Manual

IQH3-FP-V1
Operation
<SystemCode> = Q
<ParamTyp> = 2 bytes ASCII
<DataLength> = Length of <Data> in command, 2 bytes binary
<Data> = Optional additional information
Example
RP1QE5.00.00 outputs the number of unsuccessful read attempts until status 5.
Write Parameters
The WP command writes configuration parameters to the read/write device.
Command:
Response:
<SystemCode> = Q
<ParamTyp> = 2 bytes ASCII
<DataLength> = Length of <Data>, 2 bytes binary
<Data> = Optional additional information
Example
WP1QE5.00.01.05 sets the number of unsuccessful read attempts until status 5 to five
attempts.
6.7.2

Parameters

Change Tag CT
This parameter sets the tag type with which the read/write device communicates.
ParamTyp:
Default:
Value range:
For details of supported read/write tags, please see see chapter 3.5.2 and see chapter 6.1.
With the tag type "20", mixed operation of different read-only / read/write tags is possible. Only
the read-only code UID is read out with this tag type.
Example
WP1QCT.00.01.15 sets the tag type to 21
RP1QCT.00.00 reads out the currently set tag type.
1. Chiptype NXP I-Code SLIX
Note
You can also set the tag type using the CT system command. This command is described in
your IDENTControl control interface manual. We recommend using the CT system command
because the tag type is stored in the IDENTControl control interface and sent to the read/write
device at startup.
28
for IQH3-*
ASCII
WP <ChanNo> <SystemCode> <ParamTyp> <DataLength> <Data>
<CHCK> <ETX>
<Status> <ChanNo> <Data> <CHCK> <ETX>
for IQH3-*
ASCII
CT
CT = 20
dec
20 to 39 , 50
dec dec dec
dec
1
.