Table of Contents
Advertisement
IQH3-FP-V1
Certificates and Approvals
2.3
IC Information
This device complies with Industry Canada license-exempt RSS standard(s) and with Part 15
of the FCC Rules. Operation is subject to the following two conditions:
1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
IC Exposure Information
To comply with IC RF exposure compliance requirements, the antennas used for this transmit-
ter must be installed to provide a separation distance of at least 20 cm from all persons and
must not be co-located or operated in conjunction with any other antenna or transmitter.
2.4
UL Information
Technical Data and Environmental Conditions
This device is for indoor use only.
This device may be operated in altitudes up to 5000 m.
The ambient temperature range is from -20 °C ... +70 °C for operation with non-transmission
periods, or -25 °C ... +55 °C for continuous transmission mode. The Pollution degree is 2.
The maximum relative humidity is 80 % for temperatures up to 31 °C decreasing linearly to
50 % relative humidity at 40 °C.
Nominal power supply voltage is 24 V
SELV (Safety Extra Low Voltage). The Overvoltage Category II is applied. This is ensured,
when a Pepperl+Fuchs IDENTControl control interface is used.
Protection class IP67 is not included in the UL approval. The protection class is tested by
Pepperl+Fuchs SE.
The ext. circuits are intended to be connected to this unit shall be galv. separated from mains
supply or hazardous live voltage by reinforced or double insulation and meet the limits of
clauses 6.3 and 9.4 of UL 61010-1.
2.5
Other Country-Specific Approvals
All currently valid approvals can be found in the datasheet for your device at www.pepperl-
fuchs.com.
, voltage range is 20 V ... 30 V
DC
. Supply must be
DC
9
Advertisement
Table of Contents
