Pepperl+Fuchs IDENTControl IQH3-FP-V1 Manual page 29

IQH3-FP-V1
Operation
Meaning of the bytes in response .30.31.00.00.00.93.00.00.00.03
.30
.31
.00.00.00.93
.00.00.00.03
Power Transmit PT
This parameter sets the transmit power or reads out the transmit power set. The transmit power
can influence the range depending on the ambient temperature.
ParamTyp:
Default:
Value range:
By adjusting the transmit power, you can operate the device permanently at higher ambient
temperatures, since inherent heating is reduced. If the device is operated continuously with
Power transmit power with Enhanced commands, the ambient temperature must not exceed 55
°C. The ambient temperature can be a maximum of 70 °C with Eco transmission power.
Value
1
2
3
4
1. With IQC21-50
Example
WP1QPT.00.02.00.02 sets the transmit power to Eco.
RP1QPT.00.00 reads out the specified transmit power.
Protocol Mode QV
The QV parameter specifies the output protocol as a single-frame protocol or a multi-frame pro-
tocol.
The single-frame protocol complies with the P+F standard for LF systems IPH and HF systems
IQH1. If there is more than one tag in the measurement range, status A is output as a warning.
In the multiframe protocol, each tag that responded is output. An output beginning with status F,
containing the number of responses, and stopping the command is output.
ParamTyp:
Default:
Value range:
Status 0 , command has been executed successfully
ASCII
1 , IDENTControl channel 1
ASCII
147 hours, read/write device operating time
dec
3 hours, duration of the read/write command
dec
PT
PT = 4
1 = Min
2 = Eco
3 = Normal
4 = Power
Meaning Detection range
Min 90 mm
Eco 240 mm
Normal 270 mm
Power 300 mm
QV
QV = .53
.53 = S, single-frame protocol
.4D = M, multi-frame protocol
1
Ambient temperature
-25 °C– 70 °C, -13 °F– 158 °F
-25 °C– 70 °C, -13 °F– 158 °F
-25 °C– 65 °C, -13 °F– 149 °F
-25 °C– 55 °C, -13 °F– 131 °F
31