Table of Contents
Advertisement
14221-1800-2050, Rev. G
10. Pairing progress is displayed.
•
For Bluetooth 2.0 devices, a pin code screen appears.
Enter the pin code and select OK.
For Bluetooth 2.1 devices, a PASSKEY accept/deny screen appears. Select ACCEPT.
•
Accept the passkey on the Bluetooth 2.1 device as well.
11. A PAIRING COMPLETE message appears when pairing is complete. Select OK. The paired
device is then displayed in the PAIRED DEVICES list.
6.10.3 Reconnecting to Covert Bluetooth Microphone 12082-0684-01
When powering down, the radio and the microphone should be turned off one at a time, allowing
the first device to completely shut down before turning off the second device.
Power Up Sequence:
1. Power up the XL radio. Wait for power up to complete.
2. Power up covert microphone 12082-0684-01.
3. Wait for Bluetooth connection as indicated by the LED. When connected, the LED is on and
blue.
4. If the microphone LED indicates Idle or does not connect, press and release the PTT button.
6.10.4 Pair with the SCOTT EPIC 3 Radio Direct Interface (RDI) Voice Amplifier
The RDI Voice Amplifier enhances SCBA voice intelligibility when connected to the XL Extreme
Series Portable Radio via Bluetooth.
To turn the amplifier on and place into pairing mode:
1. Press and hold the power button until the LED changes from green to red. This happens in
about four (4) seconds.
2. Release the power button.
3. The LED starts blinking indicating the amp is in pairing mode.
4. Ensure the LED is the same color blinking on and off indicating pairing mode. The amp will
timeout of pairing mode quickly and the blinking will stop. If this happens before successful
pairing, power off and restart from Step 1.
82
Advertisement
Table of Contents
