Table of Contents
Advertisement
14221-1800-2050, Rev. G
5.6
MANDOWN
If enabled via radio programming, the following conditions can be configured to trigger a Mandown
condition:
•
MOTION - Mandown is declared with lack of motion.
TILT - Mandown is declared when the radio is tilted.
•
BOTH - Mandown is declared by radio tilting and lack of motion.
•
This can be useful if, for example, a radio user is in danger and has not moved for a certain
amount of time. If the user's movement falls below the configured level, then a tone begins
playing. An Emergency is declared on the channel/group based on the radio's Emergency
configuration.
5.7
STATUS MESSSAGES
The radio may display various radio Status Messages during operation. These messages are
described in Table 5-3.
MESSAGE
PTT DENIED
CALL QUEUED
SYSTEM BUSY
SCANNING
TX EMERGENCY
RX EMERGENCY
WIDE AREA SCAN
INVALID TALKGROUP
INVALID UNIT
REGISTERING
CTRL CHANNEL SCAN
BAND SCANNING
MISSED CALL
OTAR REKEY
COMPLETE
USER REGISTRATION
FAILED
36
Table 5-3: Status Messages
P25 Trunked and EDACS - The radio or talkgroup is not authorized to operate on the selected
system and/or talkgroup.
P25 Trunked and EDACS - The system has placed the call in a request queue.
P25 Trunked and EDACS - The system is busy, no channels are currently available, the queue is
full, or an individual call is being attempted to a radio that is currently transmitting.
The radio is scanning.
An emergency call is being transmitted.
An emergency call is being received. The radio displays the unit name or unit ID.
P25 Trunked and EDACS - The radio has entered the Wide Area Scan mode to search for a new
system.
P25 Trunked and EDACS - The current talkgroup is not valid for the current system. This could
happen if the site denies registration due to an unrecognized talkgroup ID.
P25 Trunked and EDACS - The current unit is not valid for the current system.
P25 Trunked only - Displayed when the radio is performing a registration/affiliation on a P25
trunking site.
P25 Trunked and EDACS - The control channel is lost and the radio has entered the Control
Channel Scan mode to search for the control channel (usually out of range indication).
P25 Trunked - Only displayed if the system is configured for "EnhancedCC" mode of operation.
When the radio cannot find a Control Channel in either the trunked frequency set or the list of
discovered adjacencies, the radio can perform a full spectrum frequency scan to find a new Control
Channel.
P25 Modes and EDACS - Another user has tried to call or page this radio. The user can view who
the caller was by pressing the up navigation button.
OTAR Rekey operation completed successfully.
User Login failed. Change selected system/zone or re-enter credentials.
DESCRIPTION
Advertisement
Table of Contents
