Figure 4-1: Radio Assembly - L3Harris XL Extreme Series Operator's Manual

14221-1800-2050, Rev. G
NOTE
1. Make sure batteries are charged per the manual supplied with the charger.
2. To attach optional belt clip, remove the existing tab from the back of the radio above the
battery compartment. Slide the belt clip into the groove.
3. Lift clip, if installed, and slide top of battery into top of battery compartment at the rear of the
radio.
4. Press down on bottom side of battery until it snaps into place.
24
Battery packs shipped in shutdown mode (i.e., 14100-4000-07, RevA) require
waking before use. To wake a battery pack, place it in the charger (with or
without radio attached; radio on or off) for less than one minute.

Figure 4-1: Radio Assembly