Figure 12-5: Enable Wi-Fi Programming Mode On Radio - L3Harris XL Extreme Series Operator's Manual

B.5 PUT THE RADIO IN WI-FI PROGRAMMING MODE
To put the radio in Wi-Fi programming mode:
1. Turn the radio off and remove the USB cable (optional).
2. Press and
power-up to enter WIFI Programming mode
3. Release the buttons when the WIFI INSTALL ACTIVE screen appears on the radio.
4. Initially, the radio displays DISCONNECTED. When the IP address is displayed, the radio is
available to be programmed.
NOTE
hold the bottom portion of the PTT switch and either of the two side YELLOW buttons on

Figure 12-5: Enable Wi-Fi Programming Mode on Radio

Refer to Section 5.37.2 for Wi-Fi Client selection information.
14221-1800-2050, Rev. G
.
123