Programming Via Rpm2; Edit Channel (Analog And P25 Conventional Only) - L3Harris XL Extreme Series Operator's Manual

14221-1800-2050, Rev. G
7.2

PROGRAMMING VIA RPM2

Radio Personality Manager2 (RPM2) is used to program the XL Extreme Series Portable Radio.
With RPM2, you can fully program the radio using cable 12082-0410-A1.
CAUTION
NOTE
7.3

EDIT CHANNEL (ANALOG AND P25 CONVENTIONAL ONLY)

Channels can be edited from the Channel Information (CH INFO) menu display. Most of the
displayed channel parameters can be modified here. Channel edits persist across a power cycle.
Loading a personality clears any channel edits. Available parameters vary depending on whether
the channel is a P25 or analog channel. The Channel Information (CH INFO) menu display is only
available if a Channel Edit Password has been programmed via RPM2.
To edit a channel:
1. From the main display, press  to access the CH INFO screen.
2. Press the up or down navigation buttons to scroll through the programmed channel settings.
3. Press the EDIT soft key.
CAUTION
4. Enter the password programmed via RPM2. You do not have to re-enter the password until
you power cycle the radio.
5. Press the ENTER soft key.
102
Removing power during radio programming or programming the radio with low
battery power could corrupt installation of firmware.
Ensure that the radio is turned off before connecting the programming cable. After
the cable is connected, then power on the radio.
Only authorized users should attempt channel editing.