Table 12-1: Wi-Fi Feature Support - L3Harris XL Extreme Series Operator's Manual

Table of Contents

14221-1800-2050, Rev. G

B.6 DISCOVERY AND PROGRAMMING IN THE RPM2 APPLICATION

1. Start RPM2.

2. Disconnect the radio from the programming cable.

3. Select the Radio tab

4. When the Wi-Fi connection button is pressed, a "Discovering Wi-Fi Radios" message is

displayed for several seconds and the radios connected to that access point with that Service

Name populate the connection list.

To connect over Wi-Fi, the currently active personality MUST have the correct

Wi-Fi parameters. Therefore, care must be taken that all personalities on a

given radio have the correct Wi-Fi parameters for the desired network.

Otherwise, activation of another personality on the radio will result in the

NOTE

inability to establish a Wi-Fi connection.

5. Select a radio or radios and perform the desired action. Only Read Personality, Write

Personality, and Load Code are supported over Wi-Fi. See the table below for the supported

combinations.

Read Single Personality

Read Multiple Personalities

Write Single Personality

Write Multiple Personalities

Load Single Code File

Load Multiple Code Files

Voice Annunciation

Feature Data

Radio Name

Install Splash Screen

6. In the Status Panel, all Wi-Fi related actions will have the prefix of "WIFI."

To help in displaying the radios, the "Connection" and "IP Address" columns are sortable.

If the Access Point is not configured to the default values from Section B.2 and the

active personality in the radio is removed, the radio loses connection to the Access

Point and must be connected over USB to write/activate a personality to reconnect

NOTE

to the Access Point.

124

and click the Wi-Fi connection button

Table 12-1: Wi-Fi Feature Support

SINGLE RADIO

MULTIPLE RADIOS

(UP TO 16)

Yes

Table of Contents