Figure 12-1: Options  Network Configuration; Figure 12-2: Wi-Fi Configuration; Figure 12-3: Service Name - L3Harris XL Extreme Series Operator's Manual

B.3 CONFIGURE THE PERSONALITY
For a radio to be programmed over Wi-Fi, the active personality on the radio must be configured
for connecting with the values that were set in Section B.2. The following steps detail how to
configure an existing radio personality.
1. In the personality, navigate to OPTIONS  Network Configuration.
2. Under the Wi-Fi Configuration section, set the Encryption Type, Network (SSID), and Network
Password.
NOTE
3. Under Network Service Configuration, the default values can remain the same. If the wireless
network is managed by another department, please coordinate with them to get it setup
correctly.
The Network Discovery Configuration  Service Name is a Unique name used by RPM2
and radios to communicate with each other. There is more information about this in Section
B.8.2.
4. After the personality is configured and saved, write it to the radio over USB and then activate
it.
Figure 12-1: Options  Network Configuration
XL radios support up to 24 different Wi-Fi networks (SSIDs). These 24 Wi-Fi
networks are considered radio administrator approved and Trusted Wi-Fi
Networks (TWiN) on which the radios can operate.

Figure 12-2: Wi-Fi Configuration

Figure 12-3: Service Name

14221-1800-2050, Rev. G
121