Use Talkaround To Bypass Repeater (Analog And P25 Conventional Only) - L3Harris XL Extreme Series Operator's Manual

14221-1800-2050, Rev. G
5.23 USE TALKAROUND TO BYPASS REPEATER (ANALOG AND P25
CONVENTIONAL ONLY)
You can bypass the repeater system to communicate directly with other radios on your current
channel's receive frequency. This is useful if you are out of range of a repeater or if a repeater is
busy. You must be in range of the other radio.
NOTE
To enable talkaround:
1. Press Menu/Select button to access the main menu.
2. Press the left or right navigation buttons to display the CALL menu.
3. Press the up or down navigation buttons to highlight TALKAROUND MODE.
4. Press the Menu/Select button to toggle TALKAROUND MODE to ENABLED.
5. The optional talkaround icon appears. Calls are now made on the receive frequency until you
disable talkaround mode via the CALL menu. Power cycling the radio does not disable
talkaround.
Or
A button or switch can be programmed to toggle talkaround enable/disabled. See Section 7.5 for
the various options that can be programmed to the radio buttons and switches.
54
In XLP R4A and later, talkaround can be enabled/disabled on a per-channel
basis. When talkaround is disabled, the
display. If talkaround is disabled for a channel (via the RPM2 personality), and
the user tries to enable talkaround via the menus or knobs while on that channel,
the radio emits a "boop" deny tone. Additionally, if talkaround is disabled on a
channel, the talkaround programmable button becomes inoperable and the
radio boops.
icon is shown on the front and top