Disable After Ptt; Auto Reset; Call Alert (Page); Send Alert - L3Harris XL Extreme Series Operator's Manual

Table of Contents

14221-1800-2050, Rev. G

4. Press the Menu/Select button to change T99 TOGGLE between ENABLED and DISABLED.

T99 is displayed in the top of the radio display when Type 99 is enabled.

A button or switch can be programmed to enable/disable Type 99 (see Section 7.5).

5.24.2 Disable After PTT

If this option is programmed using RPM2, Type 99

PTT. This allows the radio user to monitor traffic on the channel (after a PTT action) without

pressing the monitor button.

Can be used in conjunction with the "Auto Reset" option (see Section 5.24.3) to disable Type 99

after a PTT and automatically reset, or enable, Type 99 after 30 seconds.

If this option is programmed using RPM2, Type 99 is automatically reset, or turned back on, after

30 seconds.

Can be used in conjunction with the "Disable After PTT" option (see Section 5.24.2)

to disable Type 99 after a PTT and automatically reset, or enable, Type 99 after 30 seconds.

To send an alert:

1. Press the Menu/Select button to access the main menu.

2. Press the left or right navigation buttons to display the CALL menu.

3. Press the up or down navigation buttons to highlight CALL ALERT and press the Menu/Select

button.

4. Press the up or down navigation buttons to highlight the desired unit from the list and press

the Menu/Select button, or select KEYPAD to enter the Unit ID.

5. Press PTT to send the page.

1. When receiving a Call Alert, the radio displays the calling radio's name or Unit ID.

2. The radio rings and indicates a missed call. The ring sounds continuously until you press PTT,

press the CLR MISSED softkey, change group/system, or power cycle the radio.

is disabled after the radio user activates the

Table of Contents