Advanced User Guidebook; How To Set The Vertical System - Promax OD-603 Manual

3 ADVANCED USER GUIDEBOOK

Up till now, you have already been familiar with the basic operations of the
function areas, buttons and knobs in the front panel of the oscilloscope. Based
the introduction of the previous Chapter, the user should have an initial
knowledge of the determination of the change of the oscilloscope setting through
observing the status bar. If you have not been familiar with the above-mentioned
operations and methods yet, we advise you to read the section of Chapter 2
"Junior User Guidebook".
This chapter will deal with the following topics mainly:

How to Set the Vertical System.

►
How to Set the Horizontal System.
►
How to Set the Trigger System.
►
How to Implement the Sampling Setup.
►
How to Set the Display System.
►
How to Save and Recall Waveform.
►
How to Record/Playback Waveforms.
►
How to Implement the Auxiliary System Function Setting.
►
How to Implement the Automatic Measurement.
►
How to Implement the Cursor Measurement.
►
How to Use Autoscale function.
►
How to Use Executive Buttons.
►
It is recommended that you read this chapter carefully to get acquainted the
various measurement functions and other operation methods of the oscilloscope.
3.1 How to Set the Vertical System
The VERTICAL CONTROLS includes three menu buttons such as CH1 MENU,
CH2 MENU and Math, and four knobs such as VERTICAL POSITION,
VOLTS/DIV for each channel.
Setting of CH1 and CH2
►
Each channel has an independent vertical menu and each item is set
respectively based on the channel.
June 2016
17
Page