Promax OD-603 Manual page 66

Output
►
Press the Utility button, press the H1 button and turn the M to select the
Output to go to the following menu.
The description of Output menu is shown as the follows:
Function
Menu
Type
LAN Set
►
Using the LAN port, the oscilloscope can be connected with a computer
directly, or through the router to connect. The network parameters can be
set in the menu below.
Press the Utility button and turn the M knob to select the LAN Set to go to
the following menu.
The description of LAN Set menu is shown as the follows:
Function
Menu
Set
Save set
June 2016
Figure 59. Output menu
Setting Description
Trig level Output trig signal synchronously
Pass/fail Output High Level when Pass , and Low Level when Fail
Figure 60. LAN Set menu.
Setting
Press F1 button to switch between each byte, turn the M
IP
knob to change value (0~255)
Turn the M knob to change value (0~4000)
Port
Press F3 button to switch between each byte, turn the M
Netgate
knob to change value (0~255)
Press F4 button to switch between each byte, turn the M
Phy addr
knob to change value (0~FF)
Press F5 button to switch between each byte, turn the M
Net mask
knob to change value (0~255)
Save the current settings and prompt "reset to update the config"
Description
61
Page