Alternate Trigger (Od-603 Does Not Support Alternate Trigger) - Promax OD-603 Manual

Pulse Width Trigger menu list:
Menu
Single Mode
Source
Coupling
when
Mode
Holdoff
3.4.2

Alternate Trigger (OD-603 does not support alternate trigger)

Trigger signal comes from two vertical channels when alternate trigger is on. This
mode is used to observe two unrelated signals. You can choose different trigger
modes for different channels. The options are as follows: edge, video, pulse or
slope.
38
Page
Settings
Pulse Set vertical channel trigger type as pulse trigger.
CH1 Select CH1 as the trigger source.
CH2 Select CH2 as the trigger source.
AC Not allow DC portion to pass.
DC Allow all portion pass.
HF Not allow high frequency of signal pass and only
low frequency portion pass.
LF Not allow low frequency of signal pass and only
high frequency portion pass.
Polarity
Choose the polarity.
Select pulse width condition and adjust the M knob
to set time.
Auto Acquire waveform even no trigger occurred.
Normal Acquire waveform when trigger occurred.
Single When trigger occurs, acquire one waveform then
stop.
Holdoff 100ns~10s, adjust M knob to set time interval
before another trigger occur.
Reset Set Holdoff time as 100ns.
Instruction
June 2016