5.3 Fuses that Cannot be Replaced by the User
This fuse can only be replaced by qualified personnel. It is located on the
HORIZONTAL PCB and Its position identifier and characteristics are the following:
POSITION IDENTIFIER
F602
5.4 Cleaning Recommendations
To clean the cover, be sure the unit is turned off.
Do not use scented hydrocarbons or chlorized solvents. Such products may attack
the plastics used in the construction of the cover.
The cover should be cleaned by means of a light solution of detergent and water
applied with a soft cloth.
Dry thoroughly before using the system again.
Page 36
OD-514B, OD-515B & OD-545B INSTRUCTION MANUAL
CHARACTERISTICS
0.315 A – T – 250 V
5 x 20 mm for PCB
CAUTION
CAUTION
November 2000