Promax OD-603 Manual page 72

When carrying out the cursor measurement, the position of Cursor 1 can be
adjusted with the VERTICAL POSITION knob of Channel 1, and that of Cursor 2
can be adjusted with the VERTICAL POSITION knob of Channel 2.
Perform the following operation steps for the voltage cursor measurement of the
channel CH1:
Press Cursor and recall the Cursor Measure menu.
Press the H2 button and choose CH1 for Source.
Press the H1 button, the Type menu will display at the right of the
screen. Then press the F2 button to choose Voltage for Type, with
two purple dotted lines displayed along the horizontal direction of the
screen, which indicating Cursor1 and Cursor2.
According to the measured waveform, adjust the positions of Cursor1
and Cursor2 by turning the VERTICAL POSITION knob of CH1 and
CH2. Cursor increment window at the left bottom of waveform shows
absolute value of D-value of cursor 1 and cursor 2 and the present
position of the two cursors. (See Figure 66).
Carry out the following operation steps for the time cursor measurement of the
channel CH1:
Press Cursor and recall the Cursor Measure menu.
Press the H2 button and choose CH1 for Source.
June 2016
Figure 66. Waveform of Voltage Cursor Measurement.
67
Page