Table of Contents
Advertisement
Slope trigger menu list:
Menu
Single
Mode
Source
When
Threshold
&
SlewRate
Mode
Holdoff
Pulse Width Trigger
►
Pulse trigger occurs according to the width of pulse. The abnormal signals
can be detected through setting up the pulse width condition.
The Pulse Width Trigger Menu is shown as Figure 33.
June 2016
Settings
Slope
Set vertical channel trigger type as slope trigger.
CH1
Select CH1 as the trigger source.
CH2
Select CH2 as the trigger source.
slope
Slope selecting
Set slope condition; turn the M knob to set slope
time.
Adjust M knob to set the High level upper limit.
High level
Adjust M knob to set Low level lower limit.
Low level
Slew rate
Slew rate=( High level- Low level)/ Settings.
Auto
Acquire waveform even no trigger occurred.
Normal
Acquire waveform when trigger occurred.
Single
When trigger occurs, acquire one waveform then
stop.
Holdoff
100ns~10s, turn the M knob to set time interval
before another trigger occur.
Reset
Set Holdoff time as 100ns.
Figure 33. Pulse Width Trigger menu.
Instruction
37
Page
Advertisement
Table of Contents
