Promax OD-603 Manual page 57

Tip:
►
Whatever the Type of save menu is set, you can save the waveform by just
pressing the Copy panel button in any user interface. If the Storage of the
save menu is set as "External", you should install the USB disk. Please
refer to the contents below to install the USB disk and name the file to be
saved.
Save the current screen image:
►
The screen image can only be stored in USB disk, so you should connect a
USB disk with the instrument.
Install the USB disk: Insert the USB disk into the "1. USB Host port"
of "Figure 2. Right side panel". If an icon
the screen, the USB disk is installed successfully. The supported format
of the USB disk: FAT32 file system, cluster size cannot exceed 4K. Once
the USB disk cannot be recognized, you could format it into the
supported format and try again.
After the USB disk is installed, press the Save panel button, the save
menu is displayed at the bottom of the screen.
Press the H1 button, the Type menu will display at the left of screen,
turn the M knob to choose Image for Type.
Press the H4 button, the input keyboard used to edit the file name will
pop up. The default name is current system date. Turn the M knob to
choose the keys; press the M knob to input the chosen key. The length
of file name is up to 25 characters. Choose and press the Enter key of
the keyboard to end the input and store the file with the current name.
52
Page
Figure 49. Edit the File Name.
appears on the top right of
June 2016