Promax OD-603 Manual page 65

Begin to test: Press H2 button, then F2 button to select "Start", the
test will begin.
Save rule: Press H5 button, then F2 button to save the rules, which
could be called up at once when need, press F3 button to call up the
rule saved.
NOTE:
When Pass/Fail is ON, if XY or FFT is ready to run, then Pass/Fail will be
closed; under the mode of XY or FFT, Pass/Fail is unable.
Under the mode of Factory, Auto Scale and Auto Set, Pass/Fail will be
closed.
When no save setting left in the rule save, tip will be given to show "NO
RULE SAVED".
Under the status of stop, data comparing will stop, and when it goes on
running, the number of Pass/Fail will increase from the former number,
not from zero.
When the waveform playback mode is on, Pass/Fail is used to test the
played-back waveform specially.
60
Page
Figure 58. Pass/Fail test
June 2016