2.1.2
Right Side Panel
Figure 2. Right Side Panel
USB Host port: It is used to transfer data when external USB equipment
connects to the oscilloscope regarded as "host device". For example: use
this port to save waveform file into USB flash disk.
USB Device port: It is used to transfer data when external USB
equipment connects to the oscilloscope regarded as "slave device". For
example: to use this port when connect PC to the oscilloscope by USB.
COM / VGA port (Optional): To connect the oscilloscope with external
equipment as serial port, or to connect the oscilloscope with a monitor or a
projector as VGA output.
The port of trigger signal output & Pass/Fail output.
LAN port: the network port which can be used to connect with PC.
4
Page
June 2016