Removing And Replacing The Case Group Parts - Keysight N9912A Service Manual

Repair and Replacement Procedures

Removing and Replacing the Case Group Parts

Removing and Replacing the Case Group Parts
Tools Required
— T-8 TORX driver (set to 6 in-lb)
— T-10 TORX driver (set to 9 in-lb)
— Isopropyl alcohol (Use only in a well ventilated area.)
—
Before beginning any repair, disconnect the power cord.
Replacing the Kickstand, Hinge Cover, and Hinge
1. Remove, and discard, the four screws (item 1) from the kickstand hinge
Figure 7-2 Replacing the Kickstand and Hinge Cover
Keysight N9912A Service Guide
Repair and Re-assembly
cover. New screws are provided in the
Kit. Refer to "Miscellaneous Parts" on page
Repair and Re-assembly
6-12.
Kit.
7-7