Keysight N9912A Service Manual page 99

Repair and Replacement Procedures
Removing and Replacing the Case Group Parts
Figure 7-7 Replacing the Battery Cable
3. When installing the new battery cable, make sure that the connector
snaps into place.
4. Reinstall the rear case onto the front case. See
Rear
Replacing the Rear Case
1. Separate the front and rear cases. See
Cases.
2. Carefully remove the serial number label and the Windows CE label from
the back of the old rear case and apply the labels to the new rear case.
3. Remove the kickstand assembly from the old rear case and install it on the
new rear case. See
4. Remove the battery cable from the old case and install it in the new case.
See
5. Install the new rear case onto the front case. See
Rear
Replacing the Strap Handle
1. Separate the front and rear cases to the positions shown in
Separating the Front and Rear
2. Note the orientation of the strap handle, then lift it off of the dowel pins at
each end.
3. Slip the new strap handle over the dowel pins.
4. Reinstall the rear case onto the front case. See
Rear
Keysight N9912A Service Guide
Cases.
Replacing the Kickstand, Hinge Cover, and
Replacing the Battery
Cases.
Cases.
Combining the Front and
Separating the Front and Rear
Cable.
Cases.
Combining the Front and
Hinge.
Combining the Front and
Figure 7-5. See
7-13