Keysight N9912A Service Manual page 97

Repair and Replacement Procedures
Removing and Replacing the Case Group Parts
Figure 7-5 Separating the Front and Rear Cases (2)
7. Position the cases side-by-side as shown in
8. Unplug the battery cable, W10, from the A5 system board at the location
indicated.
9. The front and rear cases are now completely separated.
10.Remove the blank side panel by lifting it from the groove in the front case.
If the FieldFox serial number is below xx4910xxxx, temporarily remove the
LCD shield and verify that two strips of adhesive tape are in place as
shown in
2a on page
them by following
Keysight N9912A Service Guide
Figure 7-15 on page 7-25. To remove the LCD shield, follow
7-22. If the two strips of adhesive tape are not in place, install
step 2h on page
Figure 7-6.
7-23.
step
7-11