Keysight N9912A Service Manual page 98

Repair and Replacement Procedures
Removing and Replacing the Case Group Parts
Figure 7-6 Separating the Front and Rear Cases (3)
Replacing the Battery Cable
1. Separate the front and rear cases. See
Cases" on page
2. Note the orientation of the cable for installation of the new cable, then,
using a small flat-blade screwdriver to move the cable connector, release
the retention clips on the cable connector and remove the cable from the
rear case.
7-12
7-9.
"Separating the Front and Rear
Keysight N9912A Service Guide