Table of Contents
Advertisement
Chapter 9: Protocols
9.2.4 Adding AcuMesh Device
To add an AcuMesh device, select Add Device from the Modbus Devices page. The following
fields need to be configured:
Device Name: Enter a device name
Serial Number: Enter the serial number of the device, the serial number must be unique and
consisting of only letters and numbers.
Template: Select the correct device model
Protocol: Select RTU as the protocol
Port: Select AcuMesh as the port type
Modbus ID: Enter in the Modbus ID that corresponds to the Modbus device
AcuMesh MAC Address: Select the AcuMesh MAC address of the remote mesh transceiver of
the Modbus device. Users can click on Go to AcuMesh Scan & Configuration page to discover
remote Mesh transceivers.
Request Timeout: The default timeout setting for an AcuMesh device is 10 seconds.
61
V: 1.08 Revised: May 2020
www.accuenergy.com
Advertisement
Table of Contents
