NOTE: After adding a new device to the gateway it may take up to 3-4 minutes for the status
to show 'ON'. If after 3-4 minutes the device is showing an 'OFF' status, double-check the
configuration settings to ensure everything is set correctly.
If users need to change the configuration of an added device, they can simply click on the
device and then select the Configuration . From this page users can re-configure the device
name, port type, and Device Instance.
9.4.3 BACnet IP
The AcuLink 810 supports BACnet IP devices, users must configure and enable BACnet IP
from the BACnet page in the Protocols menu.
BACnet IP Client Enable: Enable BACnet IP
BACnet IP Client Interface: Select which interface the BACnet IP network is on, users can
select Ethernet 1, Ethernet 2, or WIFI.
www.accuenergy.com
Chapter 9: Protocols
V: 1.08 Revised: May 2020
71