Chapter 12: Alarms
12.1 Device Alarm
To configure over/under alarms in the AcuLink 810, users must log in with Admin access.
Alarms can be added to all devices including Modbus, BACnet and MBus devices. To create a
device alarm select the device from the Devices page, then select the Alarm tab.
Click on Add Alarm
Label: Users can configure the label for the alarm
Parameter: Select the Parameter you wish to monitor for over/under limit
Minimum: Enter the minimum value the parameter should be at in the Min field. Any value
lower than the Min value will trigger the alarm
Maximum: Enter the maximum value the parameter should have before it triggers the alarm
in the Max field
Click on Save to create the device alarm.
NOTE: Alarms are scanned every minute, if there is a change in data a couple seconds apart
the AcuLink 810 may not be able to register the alarm.
www.accuenergy.com
Chapter 12: Alarms
V: 1.08 Revised: May 2020
91