Table of Contents
Advertisement
Chapter 17: Reset Button
Chapter 17: Reset Button
On the AcuLink 810 unit, there is a reset button located on the back of the unit where the
Ethernet and USB ports are. This button resets the AcuLink 810 back to default meaning
that all devices, data logs, alarm/event log, and device templates will be deleted. The only
Device Template that will remain after the reset is the Modbus Gateway Function, however
all other Modbus templates will be removed.
After the reset all network communications will be restored back to default meaning the
AcuLink will have the following network settings after the reset:
• WIFI Mode - Access Point (AP) mode
• Ethernet 1 - 192.168.8.101
• Ethernet 2 - DHCP enabled
To successfully perform a reset on the AcuLink 810 gateway press and hold the reset button
for 10 seconds until all LED lights on the unit are flashing. The reset will be complete when
the LED lights stop flashing.
Reset Button
D A T A A C Q U S I T I O N S E R V E R
121
V: 1.08 Revised: May 2020
www.accuenergy.com
Advertisement
Table of Contents
