Table of Contents
Advertisement
Chapter 8: System Settings
8.1 Network
All network related configurations can be found on the Network page under the System
Status tab. Users can configure all Ethernet (ports 1 & 2), WiFi, DNS, and RSTP configura-
tions from this page.
8.1.1 Ethernet
There are two Ethernet ports on the AcuLink 810, by default Ethernet port 1 has a static IP
where as Ethernet port 2 is configured for DHCP.
Default Ethernet port 1 settings:
• IP Address - 192.168.8.101
• Submask - 255.255.255.0
• Gateway - 192.168.8.101
Default Ethernet port 2 settings:
• DHCP enabled
The Interface Status on the network page lets users know what is connected or disconnect-
ed, for example the image below shows both interface status as Connected which implies
that both Ethernet 1 and Ethernet 2 have an Ethernet cable connected to the port.
www.accuenergy.com
Chapter 8: System Settings
V: 1.08 Revised: May 2020
37
Advertisement
Table of Contents
