Teledyne Linea Color GigE LA-GC-02k05B User Manual page 88

Event Selector
Start of Acquisition
End of Acquisition
Start of Frame
End of Frame
Valid Frame Trigger
Invalid Frame Trigger
Image Lost
Invalid Line Trigger
Line Trigger Overlap
Line 1
Line 2
Line 3
Line 4
Line 3 Pulse Start
Line 4 Pulse Start
Line 5 Pulse Start
Line 6 Pulse Start
Events Overflow
Event Notification
Off
On
GigEVisionEvent
Event Line Activation
Rising Edge
Falling Edge
Any Edge
86 • Operational Reference
EventSelector
AcquisitionStart
AcquisitionEnd
FrameStart
FrameEnd
ValidFrameTrigger
InvalidFrameTrigger
ImageLost
InvalidLineTrigger
LineTriggerOverlap
Line3PulseStart
Line4PulseStart
Line5PulseStart
Line6PulseStart
eventsOverflow
EventNotification
GigEVisionEvent
eventLineActivation
RisingEdge
FallingEdge
AnyEdge
Select the Event to enable/disable with the
EventNotification feature.
Event sent on control channel on acquisition start.
Event sent on control channel on acquisition end.
Event sent on control channel on an Active Frame. This
occurs with the start of the exposure delay of the first line
of the frame.
Event sent on control channel on an Active Frame end.
Event sent on control channel when a valid frame trigger is
generated.
Event sent on control channel when a frame trigger occurs
in an invalid Trigger region. Therefore the trigger is
rejected and no frame acquisition occurs.
Event sent on control channel when an image is lost due to
insufficient memory.
Event sent on control channel when a line trigger occurs in
an invalid Trigger region. Therefore the trigger is rejected
and no frame acquisition occurs.
Event sent on control channel when a line trigger occurs in
an invalid trigger region and was delayed by the camera
into a valid region.
Event sent on control channel when a state change occurs
Line1
on line 1.
Line2 Event sent on control channel when a state change occurs
on line 2.
Event sent on control channel when a state change occurs
Line3
on line 3.
Event sent on control channel when a state change occurs
Line4
on line 4.
Event sent on control channel when a pulse is generated
on line 3.
Event sent on control channel when a pulse is generated
on line 4.
Event sent on control channel when a pulse is generated
on line 5.
Event sent on control channel when a pulse is generated
on line 6.
Event sent on control channel when all previous active
events have been disabled because the camera cannot
send them fast enough, generating an internal message
overflow. All required events must be re-enabled manually.
Enable Events for the event type selected by the
EventSelector feature.
Off The selected event is disabled.
On The selected event will generate a software event.
The selected event will generate a software event for SFNC
1.x compatibility.
Controls the activation of the line event. This is only used
for input line configurations. Output lines only generate
events on pulses start.
The event is generated on the line rising edge.
The event is generated on the line falling edge.
The event is generated on any line edge.
1.00
Expert
1.00
Expert
1.00
Expert
Linea GigE Series Camera