Table of Contents
Advertisement
Output Line Pulse Signal
Activation
Rising Edge
Falling Edge
Any Edge
Output Line Pulse Delay
Output Line Pulse Duration
Output Line Software Latch
Control
Off
Latch
Output Line Value
Active
Inactive
Line Status All
Output Line Software
Command
46 • Operational Reference
outputLinePulseActivation
RisingEdge
FallingEdge
AnyEdge
outputLinePulseDelay
outputLinePulseDuration
outputLineSoftwareLatchControl
Latch
outputLineValue
Active
Inactive
LineStatusAll
outputLineSoftwareCmd
Specifies the input line activation mode to trigger the
OutputLine pulse.
Specifies that the trigger is considered valid on the rising
edge of the source signal.
Specifies that the trigger is considered valid on the falling
edge of the source signal.
Specifies that the trigger is considered valid on the falling
or rising edge of the source signal.
Sets the delay (in µs) before the output line pulse signal.
Applicable for the OutputLineSource feature. Note, the
LineMode feature must be set to output.
Sets the width (duration) of the output line pulse in
microseconds.
When Off, the selected output line is set with the value in
Output Line Value. (RO)
Off
Output pin state set by outputLineValue.
Output pin state set by outputLineSoftwareCmd.
Sets the output state of the selected Line if the
outputLineSoftwareLatchControl = OFF. OutputLineSource
must be SoftwareControlled. If the
outputLineSoftwareLatchControl = Latch , the state of the
pin will change with the outputLineSoftwareCmd
command.
Sets the Output circuit to close
Sets the Output circuit to open
Returns the current status of all available line signals, at
time of polling, in a single bitfield. The order is Line1,
Line2, Line3, ... (RO)
Writing a value of 1 in the bit field applies the Latch value
of the outputLineSoftwareLatchControl and/or executes the
PulseOnSoftwareCmd for any output line programmed for
software control. The feature outputLineSoftwareCmd can
take any binary value and each bit set to 1 corresponds to
a Icommand for an Output.
Bit-0 is Line 3,
Bit-1 is Line 4,
Bit-2 is Line 5,
Bit-3 is Line 6
This is applicable to OutputLineSource = Pulse On: where
Software Cmd (for Pulse mode) or OutputLineSource =
SoftwareControlled and OutputLineSoftwareLatchControl =
Latch (for static states).
1.00
Beginner
DFNC
1.00
Beginner
DFNC
1.00
Beginner
DFNC
1.00
Guru
DFNC
1.00
Beginner
DFNC
1.00
Expert
1.00
Expert
DFNC
Linea GigE Series Camera
Advertisement
Table of Contents
