Table of Contents
Advertisement
Device User ID
Power-up Configuration
Selector
None
Factory Setting
UserSet1
UserSet2
UserSet3
UserSet4
User Set Selector
Factory Setting
UserSet 1
UserSet 2
UserSet 3
UserSet 4
Load Configuration
Save Configuration
Device Built-In Self Test
Device Built-In Self Test
Status
Passed
Firmware update failed
FPGA Cyclic Redundancy
Check Failed
Unexpected Error
Device Built-In Self Test
Status All
Device Reset
Device Temperature
Selector
Linea GigE Series Camera
DeviceUserID
UserSetDefault
Default
UserSet1
UserSet2
UserSet3
UserSet4
UserSetSelector
Default
UserSet1
UserSet2
UserSet3
UserSet4
UserSetLoad
UserSetSave
deviceBIST
deviceBISTStatus
FirmwareUpdateFailure
FPGA_CRC_Failure
Unexpected_Error
deviceBISTStatusAll
DeviceReset
DeviceTemperatureSelector
Feature to store a user-programmable identifier of up to
15 characters. The default factory setting is the camera
serial number. (RW)
Selects the camera configuration set to load and make
active on camera power-up or reset. The camera
configuration sets are stored in camera non-volatile
memory. (RW)
None
Keep Internal configuration.
Load factory default feature settings.
Select the user defined configuration UserSet 1 as the
Power-up Configuration.
Select the user defined configuration UserSet 2 as the
Power-up Configuration.
Select the user defined configuration UserSet 3 as the
Power-up Configuration.
Select the user defined configuration UserSet 4 as the
Power-up Configuration.
Selects the camera configuration set to load feature
settings from or save current feature settings to. The
Factory set contains default camera feature settings. User
camera configuration sets contain features settings
previously saved by the user. (RW)
Select the default camera feature settings saved by the
factory.
Select the User Defined Configuration space UserSet1 to
save to or load from features settings previously saved by
the user.
Select the User Defined Configuration space UserSet2 to
save to or load from features settings previously saved by
the user.
Select the User Defined Configuration space UserSet3 to
save to or load from features settings previously saved by
the user.
Select the User Defined Configuration space UserSet4 to
save to or load from features settings previously saved by
the user.
Loads the camera configuration set specified by the User
Set Selector feature, to the camera and makes it active.
(W)
Saves the current camera configuration to the user set
specified by the User Set Selector feature. The user sets
are located on the camera in non-volatile memory. (W)
Command to perform an internal test which will determine
the device status. (W)
Return the status of the device Built-In Self test. Possible
return values are device-specific.
Passed
No failure detected
Last firmware update operation failed.
FPGA cyclic redundancy check failed.
Switched to recovery mode due to unexpected software
error.
Return the status of the device Built-In Self Test as a
bitfield. The meaning for each bit is device-specific.
Resets the device to its power up state. (W)
Select the source where the temperature is read.
Operational Reference • 33
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
Beginner
1.00
DFNC
Beginner
1.00
Beginner
1.00
DFNC
Beginner
1.00
Beginner
1.00
Beginner
Advertisement
Table of Contents
