Teledyne Linea Color GigE LA-GC-02k05B User Manual page 63

Calibrate PRNU
flatfieldCalibrationPRNU
No Error
Calibration Failed
Camera Busy
Timeout Error
Memory Error
Target Error
Save Calibration flatfieldCalibrationSave
Reset Coefficients flatfieldResetCoefficients
Flat Field Correction flatfieldCorrectionPixelXCoordinate
Pixel X Coordinate
Flat Field Correction
flatfieldCorrectionGain
Gain
Flat Field Correction
flatfieldCorrectionOffset
Offset
Color Transformation
colorTransformationSelector
Matrix Selector
No Correction Factory
Set
White LED Factory Set
Matrix User Set1
Matrix Users Set2
LUT Mode lutMode
Off
Active
LUT Type lutType
User Defined
LUT Current Active Set lutCurrentActiveSet
LUT Set 1
to
LUT Set 8
LUT Selector LUTSelector
Luminance
LUT Size lutSize
12 Bits/Pixel
Linea GigE Series Camera
Performs Photo Response Non Uniformity (PRNU) calibration
to a targeted, user-defined value. PRNU calibration eliminates
the difference in responsivity between the most and least
sensitive pixel, creating a uniform response to light.
NoError No Error
GenericError FPN calibration failed.
BusyError The camera is busy and cannot perform the FPN calibration.
TimeoutError The FPN calibration did not finished on time.
MemoryError The camera cannot allocate the memory needed for FPN
calibration.
TargetError The PRNU calibration was not able to reach the targets.
Save the calibration performed by flatfieldCalibrationFPN and
flatfieldCalibrationPRNU to the active set.
Reset all FFC coefficients to pass-through.
Specifies the X coordinate of the flat field pixel coefficient to
access.
Sets the gain to apply to the currently selected pixel.
Sets the offset to apply to the currently selected pixel.
Selects the number of transformation matrix.
NoCorrectionFactorySet
WhiteLEDFactorySet
MatrixUserSet1
MatrixUsersSet2
Sets the enable state of the selected LUT (Lookup Table).
Off Disables the LUT.
Active Enables the selected LUT.
Displays the LUT type of the currently selected Lookup Table.
Uses the user programmable LUT.
UserDefined
Specifies the current LUT to use.
LUT_Set_1
to
LUT_Set_8
Selects which LUT to control and adjust features.
Luminance Luminance is under control.
Specify the LUT size of the selected LUT (Lookup Table).
Bpp12
No correction, factory set.
White LED, factory set.
Color matrix, user set 1.
Color matrix, user set 2.
12 bits per pixel
Operational Reference • 61
1.00
Guru
DFNC
1.00
Guru
DFNC
1.00
Guru
DFNC
1.00
Guru
DFNC
1.00
Guru
DFNC
1.00
Guru
DFNC
1.00
Guru
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Expert
DFNC
1.00
Guru
1.00
Expert
DFNC