Install Birch Log Kit 1000Blk - Valor 1000JN Installation Manual

Installation

Install Birch Log Kit 1000BLK

Material required
• Birch Log Kit, which contains:
• 13 logs
• 1 x 0.180 lb bag of embers
• Gloves, if desired
Installation
H1 H2
H6
H5 H4
Carefully unpack the kit. Note each log has its own
number stamped on the bottom. Some logs have pegs
to help you place them on the burner platform, or other
logs.
Install the logs as shown below.
1. Loosen (but do not remove) the two screws
fastening the support bracket to the burner cover
platform.
2. Slide the support bracket toward the rear of the
fi replace, as far as it will travel.
3. Tighten screws down again.
44
H3 H7
H11
H8
H12
H10
H9
H5
4. Place log H1 onto the support bracket. Note the two
tabs that fi t into the cutouts on the bottom of H1.
5. Slide H1 as far to the right as it will travel, gently
resting the log against the pilot shield.
6. Place log H4 directly on the burner, and slide it all the
way to the left.
Fuel Beds