Table of Contents
Advertisement
Installation
Install Liners
The following guidelines apply for all liners (with the
exception of the 1070RGL Refl ective Glass Liners—see
the installation manual supplied with that liner kit for
details).
1. Inside the fi rebox, on the top of each side, release
the screw of the side panel anchors if necessary so
they can rotate freely (one per side).
2. Place the rear panel against the back of the fi rebox
behind the rail retainers at bottom, with the beveled
edge facing up and toward you.
3. Insert the bottom of one of the side liner panel
between the burner plate and the side wall and
rotate it slightly to insert it totally inside the fi rebox.
Push it gently against the side wall. Rotate the side
panel anchor down to hold the panel in place.
If you have diffi culty sliding the side panels in,
you may remove the burner plate by removing
the three screws at the rear of the fi rebox and
lifting the burner plate out. This is not usually
required, except for 1070RGL kits.
Never force any piece of the liner kit into place.
4. Insert the bottom of the other side liner panel
between the burner and the side wall and rotate it
slightly to insert it totally inside the fi rebox. Push it
gently against the side wall. Rotate the side panel
anchor down to hold the panel in place.
5. Insert the top panel, beveled edge towards the back
of the fi rebox, on top of one side panel, slide it
across to rest on both side panels and rear panel.
Sliding the top panel toward the top of the fi replace
and away from the rear panel will give you more
room to maneuver the panel.
6. Gently tighten side panel anchor screws.
Liner Installation
43
Advertisement
Table of Contents
