Install Traditional Log Kit 1000Lsk - Valor 1000JN Installation Manual

Installation

Install Traditional Log Kit 1000LSK

Material required
• Traditional Log Kit, which contains:
• 13 logs
• 1 x 0.180 lb bag of embers (not pictured)
• Gloves, if desired
Installation
Carefully unpack the kit. Note each log has its own
number stamped on the bottom. Some logs have pegs
to help you place them on the burner platform, or other
logs.
Install the logs as shown below.
1. Place log H11 into the right hand side of the cavity in
front of the burner.
50
2. Place log H10 into the left hand side of the cavity in
front of the burner.
3. Place log H4 onto the groove on the burner, behind
H10 and H11. Slide it to the left until it butts up
against the end stop.
4. Place both H5 logs on either side of the H4 log at the
ends of the burner. You may need to gently press the
logs into the ends stops of the burner.
Fuel Beds