Table of Contents
Advertisement
Functional characteristics
TIG welding
1 Preparation
•
Switch off the welding machine.
•
Unscrew the gas nozzle from the welding torch.
•
Unfasten the tungsten electrode and extract.
•
Switch on the welding machine.
2 Configuration
•
Press push-button
•
Press the rotary button and select parameter
3 Alignment / Measurement
•
Applying slight pressure, press the welding torch with the collet against a clean, purged location on the
workpiece and then press the torch trigger for approx. 2 seconds. A short-circuit current will flow
briefly, which is used to determine and display the cable resistance. The value can be between 0 mΩ
and 60 mΩ. The new value is immediately saved without requiring further confirmation. If no value is
shown on the right-hand display, then measurement failed. The measurement must be repeated.
4 Restoring welding standby mode
•
Switch off the welding machine.
•
Lock the tungsten electrode in the collet again.
•
Screw the gas nozzle onto the welding torch.
•
Switch on the welding machine.
46
.
.
099-00T501-EW501
1.8.2022
Advertisement
Table of Contents
Need help?
Do you have a question about the T5.01-DC Comfort 3.0 and is the answer not in the manual?
Questions and answers