Optional) Installing The Smartmodule - Huawei SmartACU2000D User Manual

SmartACU2000D Smart Array Controller
User Manual (With PID Modules)

4.6.2 (Optional) Installing the SmartModule

Step 1 Remove the mounting ears and guide rail–mounting bracket from the
SmartModule.
Step 2 Remove the panel at the position where the SmartModule is to be installed from
the cabinet and take out the mounting bracket.
Step 3 Secure the mounting bracket to the SmartModule.
Step 4 Install the SmartModule.
Figure 4-8 Installing a SmartModule
Step 5 Connect the GE4 port on the SmartModule to the LAN port on the SmartLogger
using the network cable delivered with the SmartModule.
Step 6 Connect the preinstalled RS485 cable to the COM port on the SmartModule based
on the label.
Step 7 Connect the preinstalled power cable to the 12V 1A port on the SmartModule
based on the cable label.
Issue 05 (2023-09-26)
NO TE
To highlight the involved area, the figure does not show certain components. This is
applicable to all other similar figures.
Copyright © Huawei Technologies Co., Ltd.
4 System Installation
46