Optional) Connecting Battery Cables - Huawei SUN2000-3KTL-M1 User Manual

SUN2000-(3KTL-10KTL)-M1
User Manual
Removing DC Connectors
Before removing the positive and negative connectors, ensure that the DC switch
is OFF.
To remove the positive and negative connectors from the SUN2000, insert an
open-end wrench into the bayonet and press the wrench with force. Then remove
the DC connectors with caution.
Figure 5-14 Removing DC connectors

5.5 (Optional) Connecting Battery Cables

Prerequisites
● Battery short-circuit may cause personal injury. The high transient current
● Do not connect or disconnect the battery cables when the SUN2000 is running.
● Before connecting the battery cables, ensure that the DC switch on the
● If no battery connects to the SUN2000, do not remove the watertight caps
A battery switch can be configured between the SUN2000 and the battery to
ensure that the SUN2000 can be safely disconnected from the battery.
Issue 02 (2020-11-20)
WARNING
D ANGER
generated by a short-circuit may release a surge of energy and cause fire.
Otherwise, electric shocks may occur.
SUN2000 and all the switches connecting to the SUN2000 are OFF, and the
SUN2000 has no residual electricity. Otherwise, the high voltage of the
SUN2000 and battery may result in electric shocks.
from the battery terminals. Otherwise, the protection level of the SUN2000 will
be affected. If a battery connects to the SUN2000, set aside the watertight
caps. Reinstall the watertight caps immediately after removing the connectors.
Copyright © Huawei Technologies Co., Ltd.
5 Electrical Connections
44