Crimping The Ot Terminal - Huawei SmartACU2000D User Manual

SmartACU2000D Smart Array Controller
User Manual (With PID Modules)
Step 4 Secure the pipe fitting to the conduit.
Step 5 Check that the cable is connected correctly and securely. Then take appropriate
measures to ensure that the pipe conduit and fitting are secured reliably, and seal
the cable hole using supplied firestop putty.
Step 6 Clear foreign matter from the cabinet.
----End

5.2 Crimping the OT Terminal

● Avoid scratching the core wire when stripping a cable.
● The cavity formed after the conductor crimp strip of the OT terminal is crimped
● Wrap the wire crimping area with heat shrink tubing or insulation tape. The
● Use a heat gun carefully to avoid heat damage to the equipment.
Figure 5-4 Crimping an OT terminal
Issue 05 (2023-09-26)
NO TICE
must wrap the core wire completely. The core wire must make close contact
with the OT terminal.
heat shrink tubing is used as an example.
Copyright © Huawei Technologies Co., Ltd.
5 Electrical Connections
56