Table of Contents
Advertisement
Studio Beam 575
Installing the Lamp
The Showtec Studio Beam 575 uses the HPL-575 (ordercode
popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure:
01) Disconnect the Studio Beam 575 from power before installing the lamp.
02) Loosen the knurled bolt and remove the lamp housing (Fig.04).
03) Remove the lamp from the box and hold it by the base. Read lamp instructions. Do not touch the
lamp bulb glass. Oil on hands shortens the lamp's lifespan. If you touch the bulb glass, wipe it off with
a clean, lint free towel and rubbing alcohol.
04) Insert the lamp and fit it firmly within the lamp brackets (Fig.05).
05) Replace the lamp housing (Fig.06).
06) The Studio Beam 575 is now ready to use.
Ordercode: 30657/30658
80812G /80812O)
Fig. 04
9
as manufactured by all
Fig. 05
Fig. 06
Advertisement
Table of Contents
