Table of Contents
Advertisement
Phantom 3R Beam
Backside
03) 100-240V Pro power connector IN
04) 100-240V Pro power connector OUT
05) Ground/earth connection
06) Fuse F4AL/250V
07) 3-pin DMX signal connector IN
08) 3-pin DMX signal connector OUT
Installation
Remove all packing materials from the Phantom 3R Beam. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Installing the Lamp
The Showtec Phantom 3R Beam uses the Osram Sirius HRI lamp, 140W (ordercode 81011). Use only the
appropriate lamp for your unit. Note that product versions, that use other lamps, may be offered in the
future. Check your product specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps of higher wattage! Lamps of higher wattage generate temperatures which the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure:
01) Disconnect the Phantom from power before installing the lamp and allow the lamp to cool down.
02) Remove the 4 lamp housing screws on the back of the moving head (fig. 03).
03) Remove the lamp housing cover.
04) Remove the old lamp by pushing the lamp to the right (fig. 04) and releasing its left-hand side (fig.
05).
05) Loosen the screws and remove the lamp (fig. 06).
06) Remove a new lamp from the box and hold it by the base. Read lamp instructions. Do not touch the
lamp bulb glass. Oil on hands shortens the lamp's lifespan. If you touch the bulb glass, wipe it off with
a clean, lint free towel and rubbing alcohol.
07) Insert the new lamp into the housing and tighten the screws (fig. 06).
08) Push the lamp to the right and lock its left-hand side in position (fig. 07).
09) Replace the lamp housing cover.
10) The Phantom is now ready for use.
Ordercode: 40079
7
Fig. 02
Advertisement
Table of Contents
